|
|
|
|
|
|||
|
Acoustic diagnostics
and tomography of a shallow sea
Among the most important modern problems of LF hydroacoustics is the development of integrated network techniques for acoustic diagnostics of the ocean. This research trend stimulated by a series of foreign and Russian studies on acoustic tomography of the ocean and performed back in the 1970—1980s, combines solving both the direct problems of sound propagation in the actual ocean waveguides and the inverse problems on retrieving from measurement data the acoustic characteristics of the explored water area or of the natural or artificial inhomogeneities present in it. Since the early 2000s, new methods of acoustic tomography of a shallow sea, including various versions of mode and beam tomography, have been successfully tested at the IAP RAS; they can be the basis for the construction of advanced network-centric systems for ocean diagnostics.
In particular, high efficiency of the selective mode excitation of a hydroacoustic waveguide by a multi-source array with controlled amplitude distribution was first demonstrated in these experiments. The reverberation level significantly reduced at a low-mode excitation of the channel by the antenna matched with the first mode of the waveguide (in comparison with the excitation by a monopole source); thus, the level of fluctuations (increase in spatio-temporal coherence) of the propagating signal also markedly decreased, which is extremely important for recording the effect of mode transformation of a signal in the channel. In addition to the acoustic tomography methods based on the mode representation of a sound field in shallow water waveguides, beam diagnostic schemes for sea areas were developed at the IAP RAS in different years. As applied to the problems of acoustic monitoring in coastal areas of the ocean, the IAP RAS scientists (A. I. Khilko, I. P. Smirnov, and A. I. Malekhanov) recently developed the method of pulsed beam tomography, which is based, similarly to the LMPT method, on the use of vertical emitting and receiving antenna arrays but involves co-processing of complex-modulated pulsed signals occurred in an underwater channel and having the form of higher-frequency (up to ~ 10 kHz) sound beams matched to the waveguide. A physical model of the method and a software-algorithmic complex with an interface of control and data representation was developed to optimize the tomographic system for specific areas of a shallow sea. Operability of the method was confirmed by numerical and then model field experiments performed in conjunction with staff of the JSC RI "Atoll" in the Ivankovsky Reservoir (the Moscow Region).
The studies carried out by the IAP RAS scientists in the field of acoustic tomography of a shallow sea are now the basis for developing the principles of design and layout of network-centric systems for acoustic diagnostics of sea areas. At the present time, many maritime states pay great attention to the development of such "intelligent" systems of ocean diagnostics. These systems comprise the emitting and receiving hydroacoustic antennas (modules) that are spatially distributed, interconnected by various communication channels, controlled from a single center, and based on adaptive algorithms with allowance for unsteady conditions of the real sea and external noise, including ambient noise of the ocean. Control of the potential of such a modular system is generally also adaptive and based on the collection and analysis of data from individual elements (including a set of oceanographic sensors), models of the channel of signal propagation and generation and of the state of system resources. Adaptive control algorithms for such systems are similar to those of the self-learning neural networks and refer to the so-called cognitive algorithms.
|
|||||||||||||||||||||||||||||||||||||||||||||||
